Suzuki GSF650A Service Manual page 304

1E-11 Engine Lubrication System:
7) Remove the pin (8) and washer (9).
8) Remove the oil pump (10).
9
Installation
Installation is in reverse order of removal.
Pay attention to the following points:
• Apply GREASE to the O-ring.
CAUTION
!
Use a new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the oil pump.
NOTE
Set the oil pump shaft end "A" to the water
pump shaft.
• Install the oil pump with the oil pump mounting bolt
and then tighten them to the specified torque.
Tightening torque
Oil pump mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lbf-ft)
10
8
I718H1150057-01
"A"
I718H1150058-01
• Install the washer (1) and pin (2).
1
(a)
2
• Install the oil pump driven gear (3) and snap ring (4).
CAUTION
!
Never reuse a snap ring.
Special tool
: 09900–06107 (Snap ring pliers)
4
• Install the washer (5) and thrust washer (6) onto the
countershaft.
NOTE
The chamfer side "B" of thrust washer faces
inside.
"B"
• Install the oil pump drive sprocket (7) to the
countershaft.
NOTE
Teeth "C" on the sprocket must face the
clutch side.
(a)
I718H1150059-01
3
I718H1150060-01
5
6
I718H1150061-01