Specifications; Service Data - Suzuki GSF650A Service Manual

3A-10 Drive Chain / Drive Train / Drive Shaft:
Joint pin staking
1) Set up the special tool as shown in the illustration.
5
4
1. Tool body
2. Grip handle
3. Pressure bolt "A"
4. Adjuster bolt (Without hole)
5. Staking pin (Stowed inside grip handle behind rubber cap)
6. Bar
NOTE
Before staking the joint pin, apply a small
quantity of grease to the staking pin (5).
2) Stake the joint pin by turning (approximately 7/8 turn)
the pressure bolt [A] (3) with the bar until the pin end
diameter becomes the specified dimension.

Service Data

Drive Chain
Unit: mm (in)
Item
Final reduction ratio
Drive chain
Drive chain slack
3
1
2
6
I649G1310034-02

Specifications

Type
Links
20-pitch length
CAUTION
!
• After joining of the chain has been
completed, check to make sure that the
link is smooth and no abnormal condition
is found.
• Should any abnormal condition be found,
reassemble the chain link using the new
joint parts.
Pin end diameter specification "a"
RK: 5.45 – 5.85 mm (0.215 – 0.230 in)
3) Adjust the drive chain slack, after connecting it.
Refer to "Drive Chain Inspection and Adjustment in
Section 0B (Page 0B-17)".
Standard
3.200 (48/15)
RK 525SMOZ7Y
118 links
—
20 – 30 (1.8 – 2.2)
3
I649G1310035-02
"a"
I649G1310036-03
B817H23107001
Limit
—
—
—
323.8 (12.75)
—