Front Wheel Speed Sensor Rotor Removal And Installation - Suzuki GSF650A Service Manual

4E-71 ABS:
Removal
1) Turn the ignition switch OFF.
2) Remove the right frame cover. Refer to "Exterior
Parts Removal and Installation (GSF650/S/A/SAK7)
in Section 9D (Page 9D-6)".
3) Disconnect the rear wheel speed sensor coupler (1).
4) Remove the rear wheel speed sensor mounting
bolts.
5) Remove the rear wheel speed sensor as shown in
the rear wheel speed sensor routing diagram. Refer
to "Rear Wheel Speed Sensor Routing Diagram
(Page 4E-11)".
Installation
Refer to "Wheel Speed Sensor and Sensor Rotor
Inspection (Page 4E-73)".
Install the rear wheel speed sensor in the reverse order
of removal. Pay attention to the following points:
• Install the rear wheel speed sensor as shown in the
rear wheel speed sensor routing diagram. Refer to
"Rear Wheel Speed Sensor Routing Diagram
(Page 4E-11)".
1
I718H1450102-01
I717H2450025-01
• Check the clearance between the rear wheel speed
sensor and sensor rotor using the thickness gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – sensor rotor clearance
0.3 – 1.5 mm (0.012 – 0.059 in)
(A), (B)
Front Wheel Speed Sensor Rotor Removal and
Installation
CAUTION
!
• The ABS is made up of many precision
parts; never subject it to strong impacts or
allow it to become dirty or dusty.
• Do not hit the front wheel speed sensor
rotor when dismounting the front wheel.
Removal
1) Remove the front wheel assembly. Refer to "Front
Wheel Assembly Removal and Installation (GSF650/
S/U/SUK7) in Section 2D (Page 2D-4)".
2) Remove the front wheel speed sensor rotor (1).
CAUTION
!
When replacing the tire, make sure not to
damage the sensor rotor.
I717H2450011-01
B817H24506004
1
I717H2450026-01