Rear Brake Caliper Removal And Installation - Suzuki SFV650 Service Manual

8) Install the plug (6) to the specified torque.
Tightening torque
Pad pin plug (c): 2.5 N·m (0.25 kgf-m, 1.8 lbf-ft)
NOTE
After replacing the brake pads, pump the
brake pedal few times to check for proper
brake operation and then check the brake
fluid level.
6
(c)

Rear Brake Caliper Removal and Installation

Removal
1) Drain brake fluid. Refer to "Brake Fluid Replacement
in Section 4A (Page 4A-6)".
2) Remove the brake hose from the caliper by
removing the union bolt (1) and catch the brake fluid
in a suitable receptacle.
NOTE
• Place a clean rag underneath the union
bolt on the brake caliper to catch any spilt
brake fluid.
• Slightly loosen the sliding pin (2) to
facilitate later disassembly, if necessary.
Installation
Install the brake caliper in the reverse order of removal.
Pay attention to the following points:
• Install the caliper to the caliper bracket (1).
• Set the boot onto the sliding pin securely.
I944H1430008-02
• Install the brake pads. Refer to "Rear Brake Pad
B944H14306004
• Tighten the sliding pin (3) to the specified torque.
1
2
I944H1430009-02
3) Remove the brake pads. Refer to "Rear Brake Pad
Replacement (Page 4C-2)".
4) Pivot the caliper up and remove the caliper from the
caliper bracket.
Replacement (Page 4C-2)".
CAUTION
!
Confirm that there is a brake pad spring (2)
when installing the brake pads.
2
Tightening torque
Rear brake caliper sliding pin (a): 27 N·m (2.7 kgf-
m, 19.5 lbf-ft)
Rear Brakes: 4C-3
I944H1430010-02
1
I944H1430011-03