• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt and tighten it to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (c): 13 N·m (1.3
kgf-m, 9.5 lbf-ft)
• Apply a small quantity of thread lock to the gearshift
shaft end bolt and tighten it to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift shaft end bolt (d): 10 N·m (1.0 kgf-m,
7.0 lbf-ft)
• When installing the gearshift shaft return spring,
position the stopper "D" of gearshift arm between the
shaft return spring ends "E".
(c)
I717H1520032-01
(d)
I717H1520033-01
"E"
"D"
I718H1520057-01
Manual Transmission:
• Install the gearshift shaft assembly (6) and washers
(7) as shown.
NOTE
Pinch the gearshift arm stopper (8) with
return spring ends "F".
6
• Install a new snap ring (9).
Special tool
: 09900–06107 (Snap ring pliers)
• After installing the gearshift lever, check the gearshift
lever height. Refer to "Gearshift Lever Height
Inspection and Adjustment (Page 5B-14)".
7
7
I718H1520058-02
"F"
8
"F"
I718H1520059-02
9
I717H1520023-01
5B-17