Suzuki GSF650A Service Manual page 235

• Connect the oil pressure switch lead wire as shown.
Tightening torque
Oil pressure switch lead wire mounting bolt (e):
1.5 N·m (0.15 kgf-m, 1.1 lbf-ft)
"c": 20° ± 10°
• Apply THREAD LOCK SUPER to the driveshaft.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Tighten the engine sprocket nut to the specified
torque.
Tightening torque
Engine sprocket nut (f): 115 N·m (11.5 kgf-m, 83.0
lbf-ft)
• Tighten the speed sensor rotor bolt to the specified
torque.
Tightening torque
Speed sensor rotor bolt (g): 25 N·m (2.5 kgf-m,
18.0 lbf-ft)
(e)
" c "
I717H1140060-02
(f)
I717H1140061-02
• Before installing the engine sprocket inner cover,
apply a small quantity of SUZUKI SUPER GREASE to
the clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket inner cover. Refer to
"Engine Sprocket Removal and Installation in Section
3A (Page 3A-2)".
• Install the gearshift link arm to the gearshift shaft in
the correct position.
Gearshift lever height "d"
Standard: 44 – 55 mm (1.8 – 2.2 in)
• Install the exhaust pipe and muffler. Refer to "Exhaust
Pipe / Muffler Removal and Installation in Section 1K
(Page 1K-3)".
• Install the radiator. Refer to "Radiator / Cooling Fan
Motor Removal and Installation in Section 1F
(Page 1F-5)".
• Install the throttle body. Refer to "Throttle Body
Removal and Installation (Page 1D-10)".
Engine Mechanical: 1D-23
(g)
I717H1140062-03
"d"
I717H1140063-02