Stv Actuator Inspection; Stv Actuator Removal And Installation; Isc Valve Inspection; Isc Valve Removal And Installation - Suzuki GSF650A Service Manual

Installation
1) Move the air cleaner box backward. Refer to "Air
Cleaner Box Removal and Installation in Section 1D
(Page 1D-7)".
2) Close the secondary throttle valve by finger.
3) With the STV fully closed, install the STP sensor (1)
and tighten the STP sensor mounting screw to the
specified torque.
CAUTION
!
Replace the O-ring (2) with a new one.
NOTE
• Apply thin coat of the engine oil to the O-
ring.
• Align the secondary throttle shaft end "A"
with the groove "B" of STP sensor.
• Apply grease to the secondary throttle
shaft end "A" if necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
STP sensor mounting screw: 3.5 N·m (0.35 kgf-
m, 2.5 lbf-ft)
"B"
2
4) Make sure the STP valve open or close smoothly.
5) Adjust the position of STP sensor. Refer to "STP
Sensor Adjustment (Page 1C-4)".
6) Reinstall the removed parts.
I718H1130017-01
"A"
1
I717H1130012-01
Engine Electrical Devices:

STV Actuator Inspection

Refer to "DTC "C28" (P1655): Secondary Throttle Valve
Actuator (STVA) Malfunction in Section 1A (Page 1A-
75)".

STV Actuator Removal and Installation

Refer to "Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-11)".
CAUTION
!
• Never remove the STVA from the throttle
body.
• The STVA, IAP/TP/IAT sensor and throttle
body are available only as an assembly.

ISC Valve Inspection

Refer to "DTC "C40" (P0505, P0506 or P0507): ISC
Valve Circuit Malfunction in Section 1A (Page 1A-93)".

ISC Valve Removal and Installation

Refer to "Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-11)".
CAUTION
!
Be careful not to disconnect the ISC valve
coupler at least 5 seconds after ignition
switch is turned to OFF. If the ECM coupler or
ISC valve coupler is disconnected within 5
seconds after ignition switch is turned to
OFF, there is a possibility of an unusual valve
position being written in ECM and causing an
error of ISC valve operation.
NOTE
When the ISC valve is removed or replaced,
the ISC valve or new one should be set to
Preset position. Refer to "ISC Valve Preset
and Opening Initialization (Page 1C-5)".

ISC Valve Preset and Opening Initialization

When removing or replacing the ISC valve, set the ISC
valve to the following procedures:
1) Turn the ignition switch to ON position.
2) Set up the SDS tool.
3) Click the "Active control".
1C-5
B817H21306015
B817H21306016
B817H21306017
B817H21306018
B817H21306019