1G-12 Fuel System:
• Apply grease to the O-ring (2).
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• When installing the fuel pump assembly, first tighten
all the fuel pump mounting bolts lightly and then to the
specified torque as shown.
NOTE
Install the clamp (3) so that its base is located
in parallel with the line "B" on the fuel pump.
Tightening torque
Fuel pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lbf-ft)
3
3
"B"
Fuel Level Gauge and Fuel Level Indicator
Switch Inspection
Refer to "Fuel Level Gauge Inspection in Section 9C
(Page 9C-9)" and "Fuel Level Indicator Switch
(Thermistor) Inspection in Section 9C (Page 9C-8)".
Fuel Pump Disassembly and Assembly
Refer to "Fuel Pump Assembly / Fuel Level Gauge
Removal and Installation (Page 1G-11)".
Disassembly
2
I718H1170027-02
I717H1170009-02
I717H1170019-01
1) Remove the vessel (1).
2) Remove the fuel mesh filter (2).
3) Disconnect the lead wire (BI) (3) and remove the
connecting screw (4).
4) Remove the fuel pump assembly (5).
5
B817H21706013
B817H21706014
1
I718H1170029-01
2
I718H1170030-01
3
4
I717H1170010-01