1K-4 Exhaust System:
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Tighten the HO2 sensor to the specified torque.
Tightening torque
HO2 sensor (a): 25 N·m (2.5 kgf-m, 18.0 lbf-ft)
CAUTION
!
• Be careful not to expose it to excessive
shock.
• Do not use an impact wrench while
installing the HO2 sensor.
• Be careful not to twist or damage the
sensor lead wires.
• Do not apply oil or other materials to the
sensor air hole.
• Install the exhaust pipe gaskets (1) and muffler
connector (2).
CAUTION
!
Replace the gaskets and connector with new
ones.
NOTE
When installing a new muffler connector,
remove all of the old sealer from the exhaust
pipe and muffler. Apply the exhaust gas
sealer "A" to both the inside and outside of
the new muffler connector.
: Exhaust gas sealer (PERMATEX 1372
(commercially available))
(a)
I718H11B0011-01
1
• Tighten the exhaust pipe bolts and exhaust pipe
mounting bolt to the specified torque.
Tightening torque
Exhaust pipe bolt (a): 23 N·m (2.3 kgf-m, 16.5 lbf-
ft)
Exhaust pipe mounting bolt (b): 23 N·m (2.3 kgf-
m, 16.5 lbf-ft)
(a)
2
"A"
I717H11B0005-02
(a)
(a)
I717H11B0006-01
(b)
I718H11B0014-01