DTC (Diagnostic Trouble Code) Deleting
Use of Mode Select Switch
1) Remove the left frame cover. Refer to "Exterior Parts
Removal and Installation (GSF650/S/A/SAK7) in
Section 9D (Page 9D-6)".
2) Connect the special tool to the mode select coupler
(O – B/W) and output the DTCs.
Special tool
(A): 09930–82710 (Mode select switch)
(A)
ABS indicator
light
Mode select switch
B817H24504005
I718H1450049-02
I718H1450045-02
DTC Deleting Diagram
DTC indication
ON
OFF
ON
3) While the DTCs are being output, set the special tool
to OFF.
CAUTION
!
The DTC deletion mode starts 12.5 seconds
after the switch is set to OFF.
4) In the DTC deletion mode, switch the ABS test
switch from OFF to ON three times, each time
leaving it at ON for more than 1 second.
Permitted range of
erasing DTC
OFF
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
1 sec.
Cleaning complete
1 sec.
0.4 sec. each
0.4 sec. each
0.4 sec. each
Cleaning
start
Indicate signal
"Cleaning complete"
1 sec.
1 sec.
1 sec.
ABS:
4E-26
I718H1450050-01
I718H1450051-01
I718H1450052-01