Suzuki GSF650A Service Manual page 348

1H-8 Ignition System:
7) Loosen the front fork upper clamp bolts (4).
8) Remove the steering stem head nut and washer.
9) Remove the steering stem upper bracket (5) along
with the ignition switch (6).
10) Using a center punch, remove the ignition switch
mounting bolts.
11) Remove the ignition switch (6) from the upper
bracket.
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following points:
• Install the ignition switch and new bolts.
• Tighten each bolt until its head is broken off.
NOTE
The spare ignition switch comes equipped
with the special bolts, however, the bolts are
also individually available as spare parts.
4
6
5
4
I717H1180010-02
6
I717H1180011-01
I717H1180012-01
• First tighten the steering stem head nut (1), then
tighten the front fork upper clamp bolts (2).
Tightening torque
Steering stem head nut (a): 65 N·m (6.5 kgf-m,
47.0 lbf-ft)
Front fork upper clamp bolt (b): 23 N·m (2.3 kgf-
m, 16.5 lbf-ft)
1
(a)
• Tighten the handlebar holder set nuts (3) to the
specified torque.
Tightening torque
Handlebar holder set nut (c): 45 N·m (4.5 kgf-m,
32.5 lbf-ft)
• Route the cables, hoses and lead wires. Refer to
"Throttle Cable Routing Diagram (GSF650/S/A/SAK7)
in Section 1D (Page 1D-2)", "Front Brake Hose
Routing Diagram (GSF650) in Section 4A (Page 4A-
1)", "Front Brake Hose Routing Diagram (GSF650S)
in Section 4A (Page 4A-2)", "Wiring Harness Routing
Diagram (GSF650/S/A/SAK7) in Section 9A
(Page 9A-8)".
2
(b)
I717H1180013-02
3
(c)
I717H1180014-01