Rear Wheel Dust Seal / Bearing Removal And Installation - Suzuki GSF650A Service Manual

2D-13 Wheels and Tires:
3) Install the brake pads. Refer to "Rear Brake Pad
Replacement in Section 4C (Page 4C-2)".
Wheel rim runout
Service limit (Axial and Radial): 2.0 mm (0.08 in.)
Bearing
Inspect the play of the wheel bearings by hand while
they are in the wheel. Rotate the inner race by hand to
inspect for abnormal noise and smooth rotation. Replace
the bearing if there is anything unusual. Refer to "Rear
Wheel Dust Seal / Bearing Removal and Installation
(Page 2D-13)".
Rear Wheel Dust Seal / Bearing Removal and
Installation
Removal
1) Remove the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation (GSF650/
S/U/SUK7) (Page 2D-11)".
2) Remove the rear sprocket mounting drum assembly
(1) from the rear wheel.
3) Remove the dust seal (2).
Special tool
I649G1240014-02
4) Remove the bearings (3) on both sides using the
special tool and spacer.
Special tool
I649G1240015-02
Installation
B817H22406010
!
The removed dust seals and bearings must
be replaced with new ones.
1) Apply grease to the wheel bearings.
GREASE A or equivalent)
1
I717H1240030-01
(A): 09913–50121 (Oil seal remover)
2
(B): 09921–20240 (Bearing remover set)
CAUTION
: Grease 99000–25010 (SUZUKI SUPER
(A)
I717H1240031-01
(B)
3
I717H1240032-01
I649G1240019-02