Suzuki GSF650A Service Manual page 320

1F-14 Engine Cooling System:
6) Remove the impeller shaft (6) and washer (7).
7
6
7) Remove the mechanical seal with the special tool.
NOTE
If there is no abnormal condition, the
mechanical seal removal is not necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
8) Remove the oil seal.
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
Assembly
1) Install the oil seal with the special tool.
I718H1160014-01
(A)
2) Apply a small quantity of GREASE to the oil seal lip.
I718H1160055-01
I718H1160016-01
CAUTION
!
Replace the oil seal with a new one.
NOTE
The stamped mark on the oil seal faces
mechanical seal side.
Special tool
(A): 09913–70210 (Bearing installer set)
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
(A)
I718H1160056-01
I718H1160057-01