Suzuki GSF650A Service Manual page 406

2C-9 Rear Suspension:
5) Remove the pivot shaft end caps (4), left and right.
6) Remove the swingarm by removing the pivot shaft
and nut (5) and washer.
4
7) Remove the chain adjusters (6).
8) Remove the brake hose clamps.
9) Remove the chain buffer (7).
5
I717H1230021-01
6
I717H1230022-02
I717H1230023-01
7
I717H1230024-01
10) Remove the cushion rods (8).
Installation
Install the swingarm in the reverse order of removal. Pay
attention to the following points:
• Temporarily the cushion rod mounting nut.
NOTE
The stamped marks "A" on the cushion rod
should be face out side.
• Install the washer and swingarm pivot nut.
• Tighten the swingarm pivot nut to the specified torque.
Tightening torque
Swingarm pivot nut (a): 100 N·m (10.0 kgf-m, 72.5
lbf-ft)
8
I717H1230025-01
"A"
I717H1230026-01
(a)
I717H1230027-01