Suzuki GSF650A Service Manual page 448

3A-8 Drive Chain / Drive Train / Drive Shaft:
NOTE
The tip of pin remover (1) should be
positioned inside "a" approximately 5 mm
(0.2 in) from the end face of pressure bolt [A]
(2) as shown in the illustration.
"a"
2
"a": 5 mm (0.2 in)
2) Place the drive chain link being disjointed on the
holder part (8) of the tool.
3) Turn in both the adjuster bolt (6) and pressure bolt
[A] (3) so that each of their end hole fits over the
chain joint pin properly.
4) Tighten the pressure bolt [A] (3) with the bar.
8
6
5) Turn in the pressure bolt [B] (4) with the bar (5) and
force out the drive chain joint pin (9).
CAUTION
!
Continue turning in the pressure bolt [B] (4)
until the joint pin has been completely
pushed out of the chain.
NOTE
After the joint pin (9) is removed, loosen the
pressure bolt [B] (4) and then pressure bolt
[A] (3).
1
I649G1310025-02
3
I718H1310032-01
6) Remove the joint pin (9) of the other side of joint
plate.
CAUTION
!
Never reuse joint pins, O-rings and plates.
6 9
Drive Chain Connecting
WARNING
!
Do not use joint clip type of drive chain. The
joint clip may have a chance to drop which
may cause severe damage to motorcycle and
severe injury.
CAUTION
!
Replace the joint pins (8), O-rings (9) and
plates (10) with new ones.
4
5
I649G1310027-02
7 3
4
I649G1310028-02