Suzuki GSF650A Service Manual page 368

1J-6 Charging System:
Installation
Install the generator in the reverse order of removal. Pay
attention to the following points:
• Tighten the generator startor set bolts and CKP
sensor mounting bolts to the specified torque.
NOTE
Be sure the grommet (1) to the generator
cover.
Tightening torque
Generator stator set bolt (a): 11 N·m (1.1 kgf-m,
8.0 lbf-ft)
CKP sensor mounting bolt (b): 11 N·m (1.1 kgf-m,
8.0 lbf-ft)
(b)
• Degrease the tapered portion "A" of generator rotor
and also the crankshaft "B". Use nonflammable
cleaning solvent to wipe off oily or greasy matter and
make these surfaces completely dry.
• Install the generator rotor onto crankshaft.
"A"
1
(a)
I717H11A0010-01
"B"
I717H11A0011-01
• Hold the generator rotor with the special tool and
tighten its bolt to the specified torque.
Special tool
(A): 09930–44530 (Rotor holder)
Tightening torque
Generator rotor bolt (a): 120 N·m (12.0 kgf-m, 87.0
lbf-ft)
(A)
• Apply molybdenum oil solution to the idle gear shaft
holes.
• Apply BOND lightly to the mating surfaces at the
parting line between the upper and lower crankcases
as shown.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
(a)
I717H11A0012-03
I717H11A0013-01
I717H11A0014-01