Radiator Cap Inspection; Radiator / Cooling Fan Motor Removal And Installation - Suzuki GSF650A Service Manual

Radiator Cap Inspection

Inspect the radiator cap in the following procedures:
1) Remove the radiator cap. Refer to "Cooling Circuit
Inspection (Page 1F-4)".
2) Attach the radiator cap (1) to the radiator tester (2)
as shown.
3) Slowly apply pressure to the radiator cap.
Radiator cap release pressure
93 – 123 kPa (0.93 – 1.23 kgf/cm
4) If the radiator cap does not hold the pressure for at
least 10 seconds, replace it with a new one.
5) After finishing the radiator cap inspection, reinstall
the removed parts.
Radiator / Cooling Fan Motor Removal and
Installation
Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Drain engine coolant. Refer to "Cooling System
Inspection in Section 0B (Page 0B-14)".
3) Disconnect the radiator inlet hose (1).
1
4) Disconnect the cooling fan motor coupler (2), water
B817H21606002
5) Remove the radiator assembly (5) by removing the
I718H1160033-01
2 , 13.2 – 17.5 psi)
6) Remove the radiator heat shield (6).
B817H21606003
7) Remove the spacers (7) and mounting bolt.
8) Remove the cooling fan motor from the radiator (8).
I717H1160004-01
Engine Cooling System:
bypass hose (3) and radiator outlet hose (4).
3
bolts.
6
"A"
"A"
"A": Hooked point
7
1F-5
2
4
I717H1160005-01
5
I717H1160006-01
"A"
I718H1160073-03
8
I718H1160037-02