Language; Buzzer Volume; Initial Mode; Toner Out Stop - Konica Minolta magicolor 1680MF Service Manual

12. UTILITY mode
12.2.5

LANGUAGE

Function • Sets the language of the control panel display.
Use • To change the language of the control panel display.
• The default setting is ENGLISH.
"ENGLISH" / FRENCH / GERMAN / ITALIAN / SPANISH / PORTUGUESE
Setting/
RUSSIAN / CZECH / SLOVAK / HUNGARIAN / POLISH / JAPANESE
procedure
NOTE
• The default setting of language is subject to the setting of [PTT SETTING].
12.2.6

BUZZER VOLUME

Function
• To set the volume of alarms and the beep sounded when a key is pressed.
Use
• The default setting is LOW.
Setting/
procedure
12.2.7

INITIAL MODE

Function
• To set the mode (Copy mode or Fax mode) that the machine starts up in or returns to
after the Control Panel is reset.
Use
• The default setting is COPY.
Setting/
procedure
12.2.8

TONER OUT STOP

Function • Specifies whether to stop or continue printing when a toner empty condition is detected.
Use • To permit printing upon a toner empty condition.
• The default setting is ON.
magicolor 1680MF: "ON" / OFF
Setting/
magicolor 1690MF: "ON" / OFF
procedure
NOTE
• If [ON] is selected, printing, copying and faxing stop when the toner runs out.
12.2.9

TONER LOW

Function • To set whether to display a message when a toner near empty state is detected.
Use • Use this setting to display a message when a toner near empty state is detected.
• The default setting is ON.
Setting/
procedure
90
Field Service Ver. 1.0 Nov. 2008
OFF / "LOW" / HIGH
"COPY" / FAX
"ON" / OFF