NEC Univerge SV8100 Features And Specifications Manual page 473

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
10-03-01 ETU Setup
10-09-01 DTMF and Dial Tone Circuit
Setup
14-05-01 Trunk Group – Trunk group
Number
Direct Inward Dialing (DID)
Description/Comments
Set up and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
If the system has DTMF DID
trunks, be sure to reserve at least
one circuit for analog trunk DTMF
reception (type 0 or 2). There
must be an available receiver for
each DTMF DID trunk.
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate one
DTMF receiver for every five
devices that use them.
Put DID trunks in the same trunk
group (other than group 1). If you
have different types of DID trunks,
put each type in a separate trunk
group.
Assigned Data
1
The assigned data
varies depending on
the blade installed in
the slot. Please refer

to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available.
Trunks 1-200
Trunk Group 1-100
Priority 1-200
Default = All trunks in

Trunk Group 1 with
priority in trunk order.
Trunk 1 priority = 1
Trunk 200 priority =
200.
Issue 11.0
Level
2 3

2 - 441