NEC Univerge SV8100 Features And Specifications Manual page 352

Issue 11.0
Program
Program Name
Number
21-01-10 System Options for Outgoing
Calls – Dial Digits for Toll
Restriction Path
21-01-15 System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
21-01-16 System Options for Outgoing
Calls – Supervise Dial Detection
Timer
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
21-04-01 Toll Restriction Class for
Extensions
21-05-01 Toll Restriction Class –
International Call Restriction
Table
2 - 320
Description/Comments
If this option is programmed with
an entry other than 0, a call does
not have a talk path unless the
user dials at least the number of
digits entered in this option when
placing an outgoing call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911. Since it
is only a 3-digit number, the call
does not have a talk path,
preventing the emergency
dispatcher from hearing the caller.
This option should be kept at its
default setting of 0 to prevent any
problem with dialing 911. If the
system detects the call is
answered, by detecting Reversal
in analog trunks, this restores both
– way voice paths immediately.
Enable or Disable the Incoming
Line feature system wide. When
enabled applies code restriction
when hook flash is sent on
inbound trunk followed by dialed
digits.
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Assign a Toll Restriction class to
an extension for modes 1-8.
For the Toll Restriction Class you
select, Assign or Unassign the
International Call Restrict Table
(Program 21-06-01).
UNIVERGE SV8100
Assigned Data
1
0~24
(default = 0)

0 = Disable
1 = Enable
(default = 0)
0~64800 (seconds)
(default = 20)
Digits 0~9
(default = 4)
Day/Night Mode
1~9 (9 = Power Failure

Mode)
1~15
(default = 2)
0 = Unassign (No)
1 = Assign (Yes)

default:
1, 6~15 = 0
2~5 = 1
Code Restriction
Level
2 3


