Using The Remote Keypad Or Built-In Keypad; Guide To Keypads - Christie M Series Setup Manual

3 Operation
This section explains how to operate the projector once it has been setup and installed. Read this section and
familiarize yourself with the components ans menu options before using your projector.
3.1

Using the Remote Keypad or Built-In Keypad

The projector is typically controlled using one of the following keypads:
• Remote Keypad for wired or wireless control up to 25 feet (8m) away (includes cable for use as a wired
remote) (Figure
• Built-in Keypad located at the side of the projector
While each of the keypads provides complete control of the projector, they differ slightly in their arrangement
of keys and in what functions can be accessed directly with a key press rather than requiring use of the menu
system. You may find one keypad more convenient than another for your specific installation and application.

Guide to Keypads

Keep in mind the following guidelines:
Press keys one-at-a-time; there are no simultaneous key combinations required.
OSD function by: "press-and-hold" (2 seconds), press twice quickly, or press U
press D A
OWN RROW
Hold arrow keys down for continuous adjustment/movement in one direction. In serial networks, pause briefly
between adjustments to ensure that more distant projectors can "keep up" with the commands.
If you press a key while the projector is still responding to the previous action, such as during power-up, the
second key press may not take effect. These are toggle keys, which require you to press and hold or press twice
or press and use the up/down arrow keys.
The remote keypad controls the projector by way of wireless communications from a battery-powered infrared
(IR) transmitter. Use the remote keypad the same way you would use a remote keypad supplied with a TV or
VCR. When making key presses, direct the keypad toward the projector front or rear IR sensor. One of the two
IR sensors on the projector will detect the signals and relay the commands for internal processing. A laser
pointer is included in the remote keypad.
See the key descriptions provided for the remote keypad
the beam of the laser.
M Series Setup Guide
020-100011-04 Rev. 1 (07-2010)
Refer to Safety Warnings and Guidelines in
3-1).
K to switch off (Figure
EY
Laser radiation is emitted from the laser diode in the remote. Do not look directly into
4 Maintenance
(Figure 3-2).
3-1).
(Figure 3-1).
.
P , S
NOTE: OWER HUTTER
A K to switch on or
P RROW EY
, and
3-1