Aligning The Image With Lens Zoom And Focus; Running Auto Setup To Optimize Display Settings - Christie Mirage SST Installation And Setup Manual

If adjusting by hand without using the tool, pull out the convergence adjustment knobs to
engage them.
4. Use the Convergence test pattern to assist with adjusting the horizontal and vertical lines.
Vertical convergence and rotation is done by adjusting two knobs. Christie recommends
rotating a single knob a maximum of a quarter rotation before adjusting the second knob a
quarter rotation. For example, if using one hand, turn the left knob a quarter rotation and then
the right knob a quarter rotation, and so on. Adjusting a single knob for vertical or rotational
adjustment to an extreme before adjusting the second knob may result in the convergence
mechanism binding.
5. When complete, push in all the convergence adjustment knobs to disengage the knobs.

Aligning the image with lens zoom and focus

The lens zoom and focus adjustment allows the projected image to be focused and shifted to align
with the screen.
1. Display an image or test pattern that can be used to analyze image focus and geometry.
2. Select ZOOM.
3. Use the up and down arrows to zoom in or out of the image.
4. To exit, select Back.
5. Select FOCUS.
6. Use the up and down arrows to adjust the focus of the image.
7. To exit, select Back.
8. To refine your adjusts, repeat steps 2 to 7.

Running Auto Setup to optimize display settings

Auto Setup initiates an automated process in which the projector optimizes video settings for the
active signal. Auto Setup helps to save time in perfecting a display and you can modify the
adjustments as required.
1. Make sure of the following before running Auto Setup:
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
56