Displaying Vlan Information For Specific Ports - Foundry Networks FESX Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX

Displaying VLAN Information for Specific Ports

Use one of the following methods to display VLAN information for specific ports.
To display VLAN information for all the VLANs of which port 7/1 is a member, enter the following command:
FastIron SuperX Router(config)# show vlans e 7/1
Total PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 100, Name [None], Priority level0, Spanning tree Off
Untagged Ports: (S7)
Tagged Ports: None
IP-subnet VLAN 207.95.11.0 255.255.255.0, Dynamic port disabled
Static ports: (S7)
Exclude ports: None
Dynamic ports: None
Syntax: show vlans [<vlan-id> | ethernet [<slotnum>/]<portnum>
The <vlan-id> parameter specifies a VLAN for which you want to display the configuration information.
The <slotnum> parameter is required on chassis devices.
The <portnum> parameter specifies a port. If you use this parameter, the command lists all the VLAN
memberships for the port.
11 - 60
1 2 3 4
1 2
© Foundry Networks, Inc. December 2005