Leica GPS1200 Series Technical Reference Manual page 46

Equipment Setup
Equipment setup step-
by-step
d) Grip for pole
e) Holder for RX1210 on pole
f) Lower half aluminium pole
Step Description
1. Screw the two halves of the pole together.
2. Slide the grip onto the pole.
3. Attach the RX1210 holder and tighten the screw.
4. Slide the holder piece for the receiver onto the pole.
5. Attach the receiver holder and tighten the screw. The narrower end of the receiver
holder faces upwards.
6. Screw the GNSS antenna to the top of the pole.
7. Clip the RX1210 into the holder.
8. Lock RX1210 to the holder by pushing up at the back of the red botton of the
locking device.
9. Insert the batteries into the receiver.
10. Insert the CompactFlash card into the receiver.
11. Connect the receiver to the GNSS antenna using the 1.8 m antenna cable and port
ANT on the receiver.
12. Connect the RX1210 to port RX on the receiver using the 1.0 m cable.
13. Screw the receiver to the receiver holder with the receiver front panel facing down-
wards.
14. Press PROG on the RX1210 to switch the receiver on.
GPS1200
j) 1.0 m RX to GX cable
k) Two batteries
l) CompactFlash card
46