Equipment Setup
Next step
Step
Description
To hang the GHT56 on the tripod leg, use the hook GHT57 delivered with the
GHT56.
16.
Remove the mounting arm if attached to the GHT56. The mounting arm is used to
mount RX1250 on a pole.
17.
Screw the GHT57 onto the back of the GHT56.
18.
Hang the GHT56 on the tripod leg.
19.
Measure the antenna height using the height hook.
20.
Press PROG on the RX1250 to switch on.
RX1250 and SmartAntenna are connected via Bluetooth.
IF
the SmartAntenna interface has to be configured
the RX1250 has been pre-programmed
the RX1250 requires programming
When using the adapter and carrier, ensure that the GNSS antenna and the adapter
assembly slide down the full length of the carrier stub. An incorrectly mounted GNSS
antenna will have a direct effect on the results.
GPS1200
Refer to chapter
22.10
44
14
62