Leica GPS1200 Series Technical Reference Manual page 254

Coding
Step Description
• fixed cannot be edited.
The point code and any associated attribute values are stored with
the point. This can be automatic if <Auto STOP: Yes> and <Auto
STORE: Yes> is configured or manual with STOP (F1) and STORE
(F1).
If a point with the same point ID exists in the job, the codes, the
attribute names and the attribute values of the new and the existing
point must be identical. Should they not be identical, a screen opens
where the code or attribute mismatch can be corrected.
4. Quick coding for a point code is finished.
5. Quick coding for free codes continues from here.
The free code assigned to the quick code is searched for in the job
codelist and point occupation begins.
Attribute values for attributes of type
• normal cannot be typed in. Depending on the setting for
<Attributes:> in CONFIGURE Coding & Linework, the default
or the last used attribute values are stored.
• fixed cannot be edited.
The free code, associated attribute values and time related informa-
tion are stored. The setting for <Rec Free Code:> in CONFIGURE
Coding & Linework determines if the free code is stored before or
after the point.
GPS1200 254
Refer to
chapter
11.5