Leica GPS1200 Series Technical Reference Manual page 255

Quick coding for
lines/areas step-by-step
Coding
Step Description
6. Quick coding for a free code is finished.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. Refer to paragraph "Activate quick coding" to activate quick coding.
2. Type in the one, two or three digits of the quick code.
The current setting for <Digits:> in CONFIGURE Coding & Line-
work determines by how many keystrokes quick coding is executed.
ENTER to execute quick coding already after one or two keystrokes.
Available for <Digits: 2> and <Digits: 3> in CONFIGURE Coding &
Linework.
ESC clears digits from the entry.
The line/area code assigned to the quick code is searched for in the
job codelist.
A new line/area is created and immediately stored with that line/area
code and attributes. For the line/area ID, the line/area ID template as
defined in CONFIGURE ID Templates is used.
The system asks for mandatory attribute values.
3. Quick coding for a line/area is finished.
GPS1200
Refer to
chapter
Refer to
chapter
19.3
255