Leica GPS1200 Series Technical Reference Manual page 40

Equipment Setup
Equipment setup step-
by-step
e) RX1210
f) Holder for RX1210 on pole
g) Lower half aluminium pole
Step Description
1. Screw the two halves of the pole together.
2. Slide the grip onto the pole.
3. Attach the RX1210 holder and tighten the screw.
4. Screw the GNSS antenna to the top of the pole.
5. Clip the RX1210 into the holder.
6. Lock RX1210 to the holder by pushing up at the back of the red botton of the
locking device.
7. Insert the batteries into the receiver.
8. Insert the CompactFlash card into the receiver.
9. Place the receiver in the minipack with the top side facing outwards and the
receiver front panel to the top.
10. Fasten the strap around the receiver.
11. Connect the 1.6 m antenna cable to port ANT on the receiver.
12. Pass the 1.6 m antenna cable through a cable brake and down through the
opening in the bottom corner of the minipack flap. Refer to paragraph "Position of
cables in the minipack".
13. Draw the required amount of cable out of the minipack and tighten the cable brake.
GPS1200
l) Two batteries
m) CompactFlash card
40