Fuel Line Inspection; Fuel Pressure Relieving; Quick Connect Fitting Removal - Honda SXS700M4 Service Manual

FUEL LINE INSPECTION
FUEL PRESSURE RELIEVING
1. Remove the right rear side cover (page 2-10).
2. Turn the ignition switch to OFF (0).
3 Disconnect the fuel pump 4P connector Pl.
4. Start the engine, and let it idle until it slalls.
5 Turn the ignition switch to OFF (0).
QUICK CONNECT FITTING REMOVAL
NOTE :
Before disconnecting fuel feed hose, relieve the
pressure from the system (page 7-5).
Do not bend or twist fuel feed hose.
Fuel injector side:
1. Remove the left middle fender (page 2-8) .
2. Clean the quick
connect fitting if necessary. and
place a shop lowel over the Quick connect filling.
3. Pull and release the connector damper (1) from the , - - -
retainer [2]. Fuel injector side:
Fuel pump side:
[1]
/ I
c
I
L
[2]
FUEL SYSTEM
[2[
7-5