Backing Up The Code Image; Restoring The Code Image - 3Com 3C63100-AC-C - PathBuilder S600 Bridge/router Reference Manual

5 Restore all files by entering:
mput*
6 Exit FTP by entering:
bye
7 Telnet to the node.
8 Select [1] System Administration to display the System Administration menu.
9 Select [12] Update Flash File System.
10 Select [Y] from the confirmation prompt to update the flash file system.
Wait for the Update Completed message before continuing to Step 11.
11 Select [10] Reset Interface Card to display the Reset Port Card screen.
12 Enter [1], for the MCPU card.
13 Enter [Y] from the confirmation prompt to reset the card.
14 Repeat steps 11-13 for each card in the shelf.
You must have read/write access on the node to perform the restore operation.

Backing up the Code Image

To back up the code image, follow these steps:
1 FTP <node>.
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
n
interface).
2 Switch to binary mode by entering:
binary
3 Change directory to /fileDev/main by entering:
cd /fileDev/main
4 Change directory to /flashDev/main (type "cd /flashDev/main").
5 Get file image by entering:
get image bootmgmt.abs
Conversion of file image to bootmgmt.abs is not necessary, but is done to make
the restore seem the same as a code download, which it.
6 Exit FTP by entering:
bye

Restoring the Code Image

To restore the code image, follow these steps:
1 Move to directory that contains the bootmgmt.abs file.
2 FTP <node>.
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
n
interface).
Viewing and Configuring System Information 113