Restoring The Database; Backing Up The Code Image - 3Com 3C63400-3AC-C - PathBuilder S700 Switch Reference Manual

Restoring the Database

To restore the database, follow these steps:
You must have read/write access on the node to perform the restore operation.
1 Move to the directory you created earlier, in step 5 under "Backing up the
Database". This directory should contain only the database files.
2 FTP to the node (
FTP <node>
FTP login is the node name (upper left corner of user interface)
n
FTP password is the node password (password used to access the interface)
n
3 Switch to binary mode by entering:
binary
4 Change directory to /fileDev/disk by entering:
cd /fileDev/disk
5 Restore all files by entering:
mput*
6 Exit FTP by entering:
bye
7 Telnet to the node.
8 Select [1] System Administration to display the System Administration menu.
9 Select [12] Update Flash File System.
10 Enter y at the confirmation prompt to update the flash file system.
Wait for the
Update Completed
11 Select [10] Reset Interface Card to display the Reset Port Card screen.
12 Enter 1, for the MCPU card.
13 Enter y at the confirmation prompt to reset the card.
14 Repeat steps 11-13 for each card in the shelf.

Backing up the Code Image

To back up the code image, follow these steps:
1 FTP <node>.
FTP login will be the node name (upper left hand corner of user interface).
n
FTP password will be the node password (the password used to access user
n
interface).
2 Switch to binary mode by entering:
binary
3 Change directory to /fileDev/main by entering:
cd /fileDev/main
4 Change directory to /flashDev/main (type "cd /flashDev/main").
5 Get file image by entering:
get image bootmgmt.abs
Viewing and Configuring System Information
).
message before continuing to Step 11.
117