Table of Contents
Advertisement
Chapter 2 Set Up the Rack
2 At the front of the rack, slide the rail scopes until the rail reaches the holes
at the front.
3 While keeping the rail horizontal, place a spacer on a #20 Torx screw and
screw it through the bottom hole in the front frame and into the rail.
See the next figure.
Repeat this step for the hole above it (but not the top hole, which is for
securing the Slammer).
4 Secure the screws at the back, under the scope hook.
5 Repeat Steps 1 through 4 for the other side rail.
Figure 21 Slammer rails installed in rack
Legend
6 Tighten the four slider lock nuts that attach each rail scope to the rail.
About Component Placement
● When you place the hook in the middle of unit 32, the bottom of the
rail lines up with the bottom of unit 31.
● A 4 U Slammer rail would fill units 31-34 in the above illustration.
1 Back
2 Front
3 Slider lock nuts
56
Advertisement
Table of Contents
