Table of Contents
Advertisement
Chapter 7 Initial Configuration
Rename the Bricks
The physical Brick names indicate the physical location of the Brick in the rack.
The actual names or logical names, as seen in the Pillar Axiom Storage Services
Manager GUI, might be different.
Figure 68 Logical Brick names in the GUI
The logical name of each Brick is determined during the installation and follows
the scheme Brick001, Brick002, Brick003, and so on. It is likely that after a new
installation or a Brick upgrade, a new Brick might not have the same physical and
logical name.
Tip: Pillar Data Systems recommends that in case of a mismatch between the
physical and logical name of the Brick, the logical name must be renamed to
match the physical name of the Brick. Thus, physical Brick 1 must match the
logical Brick name Brick001 that appears in the GUI.
1 Perform a physical inspection of all the Bricks in the Pillar Axiom system to
determine the physical location of each Brick within the rack.
2 In the Pillar Axiom Storage Services Manager GUI, click the Monitor tab.
3 Under Hardware in the navigation pane, select Bricks.
Rename the Bricks
149
Advertisement
Table of Contents
