Table of Contents
Advertisement
Chapter 2 Set Up the Rack
Figure 22 Scope hook attachment
Legend
In the preceding figure, two labeled rack units, 31 and 32, are shown at the
back of the rack.
2 At the front of the rack, slide the rail scopes until the rail reaches the holes
at the front.
3 While keeping the rail horizontal, place a spacer on a #20 Torx screw and
screw the Torx screw through the center hole in the front frame and into the
rail.
About Component Placement
1 Vertical rail at back of rack
2 Rack unit 32
3 Scope hook
4 Bottom holes for each unit
5 Rack unit 31
● The bottom of unit 31 is just out of sight below its bottom hole.
● The scope hook is one-and-a-half units above the bottom of the rail.
● When you place the hook in the middle of unit 32, the bottom of the
rail lines up with the bottom of unit 31.
● A 2U Brick rail would fill units 31-32 in the above illustration.
59
Advertisement
Table of Contents
