Chapter 3 Install Components
Figure 25 Securing a 1U PDU in the bottom of a rack
Note: This image is for illustration purposes only. Your hardware
component might look different.
3 Align the ears of the PDU to the four cage nuts.
4 Insert a 10-32 x 1/2 inch screw through the top and bottom holes in the right
and left ears of the PDU and into the cage nuts.
Figure 26 An installed PDU at the bottom of the rack
Legend
Important! Do not plug the PDU into a power supply until the rack is
complete and ready for startup.
5 Secure both screws tightly.
About Power Distribution Unit Installation
1 10-32 x 1/2 inch screws
2 Rack unit (RU) marker
63