Table of Contents
Advertisement
Appendix B Safety Statements
Caution Notices
Caution
Caution
Caution
Caution
Caution
Caution
Caution
Caution Notices
It is required that, if interconnecting equipment resides
within more than one equipment rack, these racks should be
at the same ground potential.
When handling any electronic device, be sure to take
electrostatic discharge (ESD) precautions. The minimum
requirement is a properly grounded antistatic wrist strap and
grounding wire.
If removal of a FRU or blanking plate leaves a hole, block
the hole quickly with a blanking plate or by installing a
replacement FRU. Failure to do this can disrupt airflow and
seriously reduce cooling.
Ambient temperature within the rack may be greater than
that of the room. With regard to the maximum rated ambient
for Pillar Axiom 600 components, do not reduce the amount
of airflow that is required for safe operation.
Never block the ventilation holes in a chassis. Sufficient air
circulation is required for the internal components to operate
properly and to prevent the possibility of fire. Do not push
objects of any kind into the ventilation holes. Such action
could result in fire or electrical shock. Keep all liquids away
from Pillar Axiom 600 components.
Ensure that component weight distribution in the rack is
balanced. Uneven weight distribution can cause hazardous
instability. The rack should have stabilization feet or
brackets installed, or have another means that does not
permit the rack to tip when you service it. At a minimum, we
recommend that you install stabilization brackets on the rear
feet of the rack because the rack is front-heavy.
A Slammer weighs 94 pounds (42.6 kilograms). For safe
handling, use two people to lift it.
184
Advertisement
Table of Contents
