Appendix A Slammer Led Startup Progress Codes; About Led Startup Codes - Oracle Pillar Axiom 600 Hardware Installation Manual

Appendix A Slammer LED Startup Progress Codes

A A
PPENDIX
Slammer LED Startup Progress Codes

About LED Startup Codes

When a Slammer is powered on, it goes through a sequence of actions.
Generally, the time to finish these actions for a new installation is about 12 minutes.
The time to start up your system may be shorter or longer, depending on the
number of configured entities (LUNs, Snap FSs, Clone LUNs, quotas, and so on)
and, to some degree, on the configuration of Slammers and Bricks. Slammers
cannot complete the startup sequence without the Pilot being powered on and
functioning.
While a Slammer performs startup diagnostics and then waits for its runtime
image to download from the Pilot:
● The Fault LED (FLT) is off.
● The Activity LED (ACT) is green and blinks fast.
● The Status LED (ST) is green and blinks slowly.
During the remainder of the startup process, FLT and ACT are off while ST
slowly blinks amber once each second. During this time, the GUI shows the
Slammer to have a status of Booting 0xnnnn while the Pilot initializes the
Slammer' s data services components.
When the Slammer successfully completes the startup sequence, ST is steady
green.
Tip: If the front bezel Fault (FLT) LED or the private interconnect module (PIM)
FLT LED is on steady and no other fault indicators on the Slammer are lit, the
bezel may not be properly seated. Slammers always light FLT when the bezel is
off.
Tip: The FLT, ST, and ACT LED indicators are duplicated on the upper left of the
PIM in the rear of the Pillar Axiom 600 system.
If the Slammer halts during startup, the three LEDs on the back of the chassis
(FLT, ACT, and ST) or the three LEDs on the bezel (Status, Activity, and Fault)
help you identify where the Slammer halted in the startup sequence.
About LED Startup Codes 154