Table of Contents
Advertisement
Chapter 3 Install Components
1 From the Configure tab, click Storage > SAN > LUNs.
2 Select the parent LUN of all of the Clone LUNs that you want to delete.
3 Choose Actions > Delete Clones.
Result:
The system displays the Delete Clones dialog with a list of all the clones
that will be deleted.
4 When prompted to confirm the deletion, click OK.
Accept a Brick
When you add a Brick storage enclosure to an existing Pillar Axiom system, your
acceptance of the Brick allows the system to add the storage provided by the
Brick to the existing storage pool.
Prerequisites:
● The Pillar Axiom system is in a Normal state.
● The Brick has been cabled correctly according to the wiring diagrams in the
Pillar Axiom 600 SSF Cabling Reference .
● Both RAID controllers of the Brick have been powered on.
Note: After you power on a Brick, the system updates the Brick firmware.
This update can take up to 15 minutes.
● A system alert exists that states that a Brick has been added to the system.
Typically, you respond to the system alert by either accepting or rejecting the
newly added Brick. If you delete the system alert and, as a consequence, do not
accept the Brick, you can perform the Accept Brick action at a later time. This
action mirrors the functionality of the Accept Brick alert.
The Brick to be accepted can be a new one from Pillar Manufacturing or an
existing one from a different Pillar Axiom system. A Brick from a different system
is referred to as a
1 From the Monitor tab, click Hardware > Bricks.
2 Choose Actions > Accept Brick.
3 (Optional) Select a domain from Storage Domain drop-down list.
Replace a Brick Storage Enclosure
foreign Brick.
82
Advertisement
Table of Contents
