Table of Contents
Advertisement
Chapter 3 Install Components
Install a Brick Storage Enclosure
When you install the Bricks, work from the bottom of the rack toward the top. If
you have additional racks of Bricks, install those Bricks from the top down in the
additional racks.
Required tool: Torx T20 screw driver, tie wraps, and velcro ties.
Note: Brick storage enclosures are packaged and shipped separately from the
Pillar Axiom 600 system.
1 Put on an antistatic wrist strap, ground strap, or heel strap and attach the
grounding wire to ground.
2 At the front of the rack, insert the Brick onto the mounting rack rails and
slide into place.
Important! When you slide the component into the rack, keep the Brick
level to avoid bending the rail supports, which would cause difficulty when
inserting a component below.
Figure 38 Insertion of a Brick
Install a Brick Storage Enclosure
A Brick weighs up to 65 pounds (29.5 kilograms). For
Caution
safe handling, use two people to lift it.
75
Advertisement
Table of Contents
