Table of Contents
Advertisement
Chapter 3 Install Components
Figure 35 Insertion of a Slammer
3 Put a spacer on a 10-32 x 1/2 inch Torx screw, then insert the screw
through the hole in the ear on the left side of the Slammer.
4 Push the Slammer so that its ears and the spacers rest against the vertical
channels, then start the Torx screws with your fingers.
5 Use a #20 Torx wrench to secure the screws to the rack.
Note: This step only keeps the Slammer in place; the screws provide no
other support.
6 Repeat Steps 3 through 5 for the right side of the Slammer.
7 (Pillar Axiom 600 systems only) If you have a two, three, or four Slammer
system, install the remaining Slammers now.
Important! Do not apply power to the Slammers until instructed to do so.
Related references
Cable Length Limits for SAN Fibre Channel Connections
•
Install a Slammer Storage Controller
72
Advertisement
Table of Contents
