Table of Contents
Advertisement
Chapter 6 Complete the Installation
Verify the Front Status LEDs
You can verify the installation of the hardware by checking the LEDs on the Pilot,
Slammer, and Brick bezels.
1 Verify the Pilot CU LEDs are steady green and not blinking.
If the LEDs are off, ensure that the PDU circuit breakers are receiving
power and that you have turned them on within a 10 second period of time.
Figure 58 Pilot bezel LEDs
Legend
2 If the Pilot has a DC power switch in the back, make sure that the DC
power switch is on.
Verify the Front Status LEDs
1 CU 0 LED
2 CU 1 LED
128
Advertisement
Table of Contents
