Table of Contents
Advertisement
Chapter 2 Set Up the Rack
1 At the front of each rack roof, use a T30 Torx® screwdriver to remove the
two adjacent Torx-head screws and set them aside.
2 Place a baying plate over the two holes.
Figure 5 Roof baying plate attachment
Legend
3 Insert a Torx screw (from Step 1) into each plate hole.
4 Re-seat the Torx screws loosely.
5 Repeat Steps 1 through 4 for the two holes at the back of the roof.
6 At the bottom of the adjacent rack sides, remove the anti-tip brackets, if
any, and unscrew the anchor bolts.
Rack Position
1 Roof baying plates
2 M12 Torx screws
32
Advertisement
Table of Contents
