Table of Contents
Advertisement
Chapter 2 Set Up the Rack
Install a Pair of Slammer Mounting Rails
1 Hang the scope hook in the appropriate hole at the back of the rack, as
shown below. These rail scopes are always used for components that take
up at least two rack units.
Figure 20 Scope hook attachment
Legend
In the preceding figure, two labeled rack units, 31 and 32, are shown at the
back of the rack.
About Component Placement
1 Rack unit 32
2 Rack unit 31
3 Vertical rail at back of rack
4 Scope hook
5 Bottom holes for each unit
● The bottom of unit 31 is just out of sight below its bottom hole.
● The scope hook is one-and-a-half units above the bottom of the rail.
55
Advertisement
Table of Contents
