System Configuration; Configuring A Newly Installed Library; Setting The System Time; Set The Date And Time - Oracle StorageTek SL150 User Manual

This chapter focuses on the procedures for configuring the SL150 tape library. After
you complete the physical installation and initial configuration tasks specified in the
Installation Manual (see the
you perform the tasks described below to finish initial setup. Thereafter, you should
refer to this chapter whenever you need to modify parts of the initial configuration.

Configuring a Newly Installed Library

During the installation of a new library, you run an initial-configuration wizard from
the local operator console on the library base module (see the Installation Manual in the
StorageTek SL150 Modular Tape Library
wizard lets you specify a secure password for the default administrator account and
basic network connectivity, so that you can log in to the remote user interface using a
web browser. You then finish the configuration process remotely, as described in this
chapter.
During initial configuration, you should perform the following tasks:

Setting the System Time

■
Reserving Storage Slots for System Use
■
Checking and Updating Firmware
■
Network Administration
■
Partitioning
■
Configuring Drive Cleaning Operations
■
Configuring Tape Drives
■
Creating Additional User Accounts
■
Setting Up SNMP Monitoring and
■
Setting the System Time
If you did not set the time from the local operator panel or if, at any point, you need to
reset it, proceed as follows.

Set the Date and Time

Select Settings from the menu on the left side of the interface. A set of tabbed
1.
property sheets appears.

System Configuration

3
"Customer Documentation Library"
Customer Documentation Library
Management.
3
on page ix for details),
for details). The
System Configuration 3-1