Configuring Mpls L2Vpn; Configuring Vpws; Configuring Vpls - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (MPLS Volume)
St- Command
ep
1
ZXR10(config)#
2
ZXR10(config-if)#
p-address>[<static-p>]<vc-id>[tunnel <tunnel
number>][mtu <mtu value>]
54 Confidential and Proprietary Information of ZTE CORPORATION
and a VC label of 203 to PE3. PE3 distributes a VC label of 301 to
PE1 and a VC label of 302 to PE2.
A host which connects to CE1 sends a frame with source MAC ad-
dress X and destination MAC address Y to PE1. PE1 does not know
which PE owns MAC address Y. It adds label of 201 in this frame
and sends it to PE2. Similarly, it adds the label of 301 in this frame
and sends it to PE3.
After PE2 receives this frame, it learns source MAC address X of
this frame and binds MAC address X with VC label of 102 which
was distributed by PE1.

Configuring MPLS L2VPN

Configuring VPWS

To configure VPWS, perform the following steps:
netcard vpn
mpls xconnect [static-pw]<i
Configure remote interface address and tunnel ID, establish VPWS
between local interface and remote interface.
unique on local node and the corresponding interface on remote
node must have the same vc-id. Network-unique PW identifier is
composed of remote node IP address and vc-id. With parameter
tunnel number, MPLS label is assigned by specified tunnel, without
parameter tunnel, the label is assigned by LDP. Mtu value can be
specified by mtu parameter.

Configuring VPLS

To configure VPLS, perform the following steps.
Function
This configures micro code
version. It is required to
reboot line interfaces with
network processor after this
command is configured.
This starts VPWS
configuration on layer 3
VLAN interface.
Vc-id must be