Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
This example sets the interface to ignore the check of length of
packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis ignore-mtu
isis lsp-interval
Use this command to set the time interval of sending LSP packets.
Restore default with the no form of this command.
Interface configuration
isis lsp-interval <interval>[level-1 | level-2]
no isis lsp-interval [level-1 | level-2]
<interval>
level-1
level-2
If level-1 or level-2 is not specified, this command acts on both
level-1 and level-2 at the same time.
This example sets the time interval of sending LSP packets to 1
second.
ZXR10(config)#interface fei_1/1
ZXR10(config-intf)#isis lsp-interval 1
ZXR10(config-intf)#isis lsp-interval 1 level-1
ZXR10(config-intf)#isis lsp-interval 1 level-2
isis ipv6 metric
Use this command to configure the metric value of IPv6.
Interface configuration
isis ipv6 metric <metric-value>[level-1 | level-2]
no isis ipv6 metric [level-1 | level-2]
<metric-value>
level-1
level-2
This example sets the IPv6 metric value of interface fei_1/1 as 66.
ZXR10(config)#interface fei_1/1
Confidential and Proprietary Information of ZTE CORPORATION
Time interval, unit: second, range: 1~65535,
default: 2 seconds
The router is in area Level-1
The router is in area Level-2
Metric value of the interface, range:
0~16777214
The router is in area Level-1
The router is in area Level-2
Chapter 4 IS-IS Protocol
107