Step
3
4
3. Verify the configurations.
Command
ZXR10#
entry [interface <interface-name>]| neighbor [interface
<interface-name>]| statistic [interface <interface-name>]}
4. Maintain the LLDP.
Command
ZXR10#
| send]| all }
ZXR10(config-lldp)#
ZXR10(config-lldp)#
ZXR10(config-if-interface-name)#
ZXR10(config-if-interface-name)#
– End of Steps –
14.3 LLDP Configuration Examples
14.3.1 LLDP Neighbor Configuration Example
Configuration Description
As shown in
SJ-20140504150128-007|2014-05-10 (R1.0)
Command
ZXR10(config-lldp-if-interface-name)#
{enable | disable}
ZXR10(config-lldp-if-interface-name)#
ighbor <num>
show lldp {config [interface <interface-name>]|
debug lldp { adjacency | event | packets [receive
clearneighbor
clearstatistic
Figure
14-2, it is required to configure LLDP on gei-1/1 of R1.
lldp-tx
maxne
Function
This shows LLDP related information,
event information and packets
sending and receiving information.
This clears an LLDP neighbor
relationship that has been established.
This clears LLDP statistical
information.
This clears an LLDP neighbor
clearneighbor
relationship that has been established
on an interface.
This clears LLDP statistical
clearstatistic
information on an interface.
14-5
ZTE Proprietary and Confidential
Chapter 14 LLDP Configuration
Function
Enables/Disables LLDP send
function in an interface.
This configures the maximum
number of neighbors that can be
discovered by LLDP, in the range
of 1-8, with the default value of 8.
Function
This shows LLDP configuration
information, detailed neighbor
information, brief neighbor
information and statistical
information.