Using The Service Personnel Screen; Checking Firmware Version - Intellitouch User Manual

Using the Service Personnel Screen

IntelliTouch system information such as circuit configurations are stored in the outdoor control panel memory.
System information relating to user interface settings and ordering of controllers is retained locally at the
controller (indoor control panel, MobileTouch, iS10 etc.). All system information is backed up and updated to
all indoor control panels, MobileTouch controllers, and the main outdoor control panel periodically. If required,
you can upload or down load the current system configuration to and from the outdoor control panel and
controllers. This feature is available from the Service Personnel screen.

Checking Firmware Version

The IntelliTouch factory installed operating system software is known as firmware. There is a different firmware
program loaded on the controllers (indoor control panel and MobileTouch) and the outdoor control panels.
Every time the firmware version is changed it is assigned a new release level number (version #). Changes are
made to the firmware to either add functionality or enhance performance. If you need to determine the firmware
revision level on the system, perform the following steps.
To check the system firmware version:
Getting There
MENU SETUP ADVANCED
Go to the Advanced screen.
1. From the Advanced screen, press buttons 2 and 4 at the same time. The Service Personnel screen is
displayed.
2. Press the button next to System Version Info. The firmware version is displayed for the Indoor Control
Panel (UIC) and Outdoor Control Panel (UOC).
4. Press Back to exit.
5. Press Exit to return to the main screen.
Note: Different controllers may have different revision levels depending on when they were installed.
To determine the firmware version of each controller repeat the above steps for each controller.
CIRCUIT NAMES
CIRCUIT FUNCTIONS
CONFIGURE VALVES
SPA, RF, & PHONE REMOTES
MENU/SETUP/ADV
BACK
2
Press both buttons at the same time to
access the Service Personnel screen
CALIBRATE
EXIT
4
SEND IMAGE TO OUTDOOR
IntelliTouch Pool and Spa Control System User's Guide
85