Table of Contents
Advertisement
42
Setting up Lighting Options (Color Swim and Color Set) -
least two SAm and/or SAL and/or Fiberworks Lighting products controlled by separate AUX circuits
There can be up to 12 light circuits on the main Lights screen. From this screen you can activate the "Color
Swim" and Color Set" special lighting features. These special features each must have their own relay and
separate circuits.
Color Swim and Color Set
Although the same screen is used to program the Color Swim and Color Set features, these two special lighting
effects operate independently of each other. It may take up to a minute or more for Color Swim or Color Set to
operate as programmed, depending on what kind of light you are activating and what state it was in when the
effect was activated.
•
Color Swim - Allows any combination of up to 12 SAm, SAL, and/or FIBERworks lighting circuits to be
preset to transition through colors in sequence, giving the appearance of the colors swimming across the
water. The delay in sequencing each light can be adjusted to customize the display for your pool. This feature
requires the use of at least two SAm, SAL, and/or FIBERworks lighting products controlled by separate
AUX circuits and relays.
•
Color Set - Allows any combination of up to 12 SAm, SAL, and/or FIBERworks lighting circuits to be
preset to specific colors. For example, you can set the colors for red, white, and blue, or red and green.
•
Sync - Switches all color changing lights ON to synchronize their colors.
•
Smart Start (
on at a specific time, automatically begin changing their colors. For more information see page 15.
Setting up Color Swim and Color Set with S Am , S AL , or FIBER works
Both the Color Swim and Color Set feature can be configured and operated from the Lights screen, but
operate independently of each other. Depending on what kind of light is being switched on and what state it was
in when the lighting effect was activated, it may take up to a minute or more for Color Swim or Color Set to
operate as programmed. The Color Swim feature creates the illusion of bands of colors moving through the
water. This is accomplished by switching on each light with a specific color in a specified order at different time
intervals. The order and time delay between lights can be mixed and matched to create many different effects.
For example, colors moving left to right, one body of water to another, from the middle outward, etc.
To assign light circuits to the Lights screen:
Be sure the auxiliary circuits that control the lights have been assigned names. Then verify that
Before Starting:
SAm and SAL lights have been assigned in the "CIRCUIT FUNCTIONS" as SAM and SAL lights. If
FIBERworks lighting is being used, it also has to be set up as a PHOTON GENERATOR for the circuit
controlling the light bulb, and COLOR WHEEL for the circuit controlling the color wheel (see page 41).
Setting up Color Swim and Color Set lights
The following steps (see next page) describes how to setup an AUX circuit to control the Color Swim and
Color Set lighting features. The first step is to assign the circuit light function an auxiliary relay circuit (AUX 1),
then assign the circuit name for that light circuit. The light circuit name will appear on the main screen. Each light
(SAM or SAL) must also be assigned a circuit function. If the circuit function has been assigned, start at Step 5
(see next page).
IntelliTouch Pool and Spa Control System User's Guide
-
SS_Yes and SS_No)
The Smart Start feature allows light circuits that are programmed to switch
Requires use of at
Advertisement
Table of Contents
Troubleshooting
