Vacuum Parameters - Intellitouch User Manual

62
IntelliFlo VF 3050 pump setup

Vacuum parameters

Use the Vacuum mode to clean the pool manually. To operate the pump in Vacuum mode, place the IntelliTouch
outdoor control panel in "Service Mode," and stop the IntelliFlo pump. The pool service person can then press
the Vacuum button on the IntelliFlo pump. The pump would operate at the preset Vacuum parameters, then the
blockage alert parameter would be cleared and the pump will stop. Vacuum mode only operates in flow control
mode. Operating in Vacuum mode shuts off all of the pumps sensors. This mode is identical to IntelliFlo
"Feature 1 and 2" except that you can manually start this mode using the Vacuum button. Safety considerations
should be made when setting the Vacuum flow parameter.
CAUTION: Since vacuuming is manual work and the user will be at the pool, the "Blocked System" will be switched
off, it is important not to use any kind of automatic cleaners, (such as Kreepy Krauly, etc.) with Vacuum mode.
To set the vacuum parameters:
1. From the main pump screen, press the left side button next to the select IntelliFlo pump.
2. On the next screen, press the left side button next to SET PARAMETERS then on the following screen
select VACUUM PARAMETERS.
3. To adjust one of the parameters, use the right button to increase and the left button to decrease the parameter
value.
4. When finished, press the lower SAVE button to save the setting. The previous pump parameters screen is
displayed. To modify another parameter select a feature from the parameter list. To exit, press the EXIT
button to return to the Equipment screen.
Press this
button to
increase
value
Description
Vacuum Flow GPM (50 GPM default)
This setting sets the GPM that the pool
vacuum will use.
Vacuum Time Mins. (10 minutes default)
This parameter can be set from 1 to 600 minutes.
The typical setting is 10 minutes. This setting sets
the amount of time you wish to run the pool vacuum.
IntelliTouch Pool and Spa Control System User's Guide
(Continued)
VACUUM FLOW GPM 130
VACUUM TIME MINS 75
MENU/SETP/EQUIP/IFLO/PARAMS/VACUUM
SAVE
BACK EXIT
Save
button
Press this
button to
decrease
value
Value
15-130 GPM
1-600 minutes (10 hours)